The TALBOT Push Fit pushfit converter with female thread can be pushed into any appropriately sized metric Pushfit connector converting it to a female iron swivel adapter (parallel). It is available in 7 sizes

• 20mm x 1/2″ TALBOT Push Fit pushfit converter with female thread – Talbot E5062
• 20mm x 3/4″ TALBOT Push Fit pushfit converter with female thread – Talbot E5061
• 25mm x 1/2″ TALBOT Push Fit pushfit converter with female thread – Talbot E5060
• 25mm x 3/4″ TALBOT Push Fit pushfit converter with female thread – Talbot E5058
• 25mm x 1″ TALBOT Push Fit pushfit converter with female thread – Talbot E5059
• 32mm x 1″ TALBOT Push Fit pushfit converter with female thread – Talbot E5057
• 32mm x 1 1/4″ TALBOT Push Fit pushfit converter with female thread – Talbot E5056

The Talbot Pushfit joint is a tried and tested method of jointing low, medium and high density polyethylene water pipe, from 16mm to 180mm and their imperial equivalents. The fitting is quick and easy with no nuts to leave undone – simply push the pipe into the joint. The joint’s grip and seal on the pipe increases with water pressure and tensile load which means that the pipe will burst or neck before the joint fails.

Using a common body and only two sets of interchangable components, Talbot Pushfit will connect to metric PE pipes and their imperial equivalents